Mechanical Behavior of a Tri-modal Al Matrix Composite
Academic Article
Overview
Research
Identity
Additional Document Info
Other
View All
Overview
abstract
AbstractMechanical milling at cryogenic temperatures (cryomilling) was applied to fabricate a composite powder with 20 wt. % B4C (submicron-to-several microns in size) in a nanocrystalline (NC) 5083 Al matrix. A uniformly blended powder with 50 wt. % cryomilled composite powder and 50 wt. % coarse-grained (CG) 5083 Al powder was degassed, cold isostatic pressed (CIPped) and extruded to form a composite with 10 wt. % B4C, 50 wt. % CG 5083 Al and balance NC 5083 Al. This tri-modal material was then tested for mechanical behavior under compressive and tensile load conditions at various temperatures. The composite exhibited an extremely high yield stress at room temperature, but limited ductility. Although the composite lost its strength at elevated testing temperatures rapidly, the retained strength was still much higher than that of the conventional 5083 Al. The composite exhibits its highest ductility of 26% at 200C under tensile load. In compression, it plastically deformed uniformly at all the elevated temperatures (373 K) and did not fracture even when the deformation exceeded 30%. The microstructure of this composite, including the distribution of each phase, the grain sizes of the Al matrix, the interfaces between these three phases, and the fracture surfaces were characterized using transmission electron microscopy (TEM) and optical microscopy (OM) techniques. The relationship between the microstructures and mechanical properties was discussed.
