KINEMATICS OF AN ARTICULATED CONNECTING ROD AND ITS EFFECT ON SIMULATED COMPRESSION PRESSURES AND PORT TIMINGS Conference Paper uri icon

abstract

  • 2017 ASME. This study discusses the motion of the articulated connecting rod of an integral-engine compressor and the effect of the kinematics on in-cylinder pressure and port timings. A piston position modeling technique based on kinematics and engine geometry is proposed in order to improve the accuracy of simulated in-cylinder compression pressures. Many integral-engine compressors operate with an articulated connecting rod. For this type of engine-driven compressor, two power pistons share a crank throw with the compressor. The hinge pins that attach the power piston connecting rods to the crank are offset, causing the piston locations for each cylinder to be out of phase with each other. This causes top dead center to occur at different crank angles, alters the geometric compression ratio, and also changes the port timings for each cylinder. In this study, the equations of motion for the pistons of the four possible compressor/piston configurations of a Cooper- Bessemer GMW are developed. With the piston profiles, the intake and exhaust port timings were determined and compared to those of a slider-crank mechanism. The piston profile was then inputted into GT-POWER, an engine modeling software developed by Gamma Technologies, in order to obtain an accurate simulation match to the experimental in-cylinder pressure data collected from a Cooper-Bessemer GMWH-10C. Assuming the piston motion of an engine with an articulated connecting rod is similar to a slider-crank mechanism can create a difference in port timings. The hinge pin offset creates asymmetrical motion about 180-aTDC, causing the port timings to also be asymmetrical about this location. The largest differences are shown in the intake port opening of about 10 and a difference in exhaust port opening of about 7 when comparing the motion of the correct configuration to the motion of a slidercrank mechanism. It is shown that properly calculating the piston motion profiles according to the crank articulation and engine geometry provides a good method of simulating in-cylinder pressure data during the compression stroke.

published proceedings

  • PROCEEDINGS OF THE ASME INTERNAL COMBUSTION ENGINE FALL TECHNICAL CONFERENCE, 2017, VOL 2

author list (cited authors)

  • Fieseler, K., Jacobs, T. J., & Patterson, M.

publication date

  • January 2017